Be SURE the sensor holes (one on the vertical surface, one on the
horizontal surface) are free of lint, dust, anything that would block
the sensor's beam. Clean gently with a toothpick and then a damp
(not wet) q-tip.
Good luck!
Mark Williams
Consulting Librarian
Professional Services for Conferences, Districts, Workshops
markwilliams@makaw.net
--------------------------------------------------------------------------
"The closest thing you will find to an orderly universe is a good
library" Ashleigh Brilliant
--------------------------------------------------------------------
Please note: All LM_NET postings are protected by copyright law.
You can prevent most e-mail filters from deleting LM_NET postings
by adding LM_NET@LISTSERV.SYR.EDU to your e-mail address book.
To change your LM_NET status, e-mail to: listserv@listserv.syr.edu
In the message write EITHER: 1) SIGNOFF LM_NET 2) SET LM_NET NOMAIL
3) SET LM_NET MAIL 4) SET LM_NET DIGEST * Allow for confirmation.
* LM_NET Help & Information: http://www.eduref.org/lm_net/
* LM_NET Archive: http://www.eduref.org/lm_net/archive/
* EL-Announce with LM_NET Select: http://lm-net.info/
* LM_NET Supporters: http://www.eduref.org/lm_net/ven.html
* LM_NET Wiki: http://lmnet.wikispaces.com/
--------------------------------------------------------------------
LM_NET
Mailing List Home